2010 Kawasaki Z1000
Gone during the 2009 model year, the Big Zed is back and one glance at the ‘10 Z1000 makes plain that there’s more than bold new graphics afoot. The styling of the Big Z changed dramatically changed. The profile is sharper, more angular, dialing down the nakedness of its predecessor with black bodywork covering the front fork and belly of the design. Perhaps to combat the disparity in popularity of naked designs in American, compared to Europe, where they are often top sellers, Kawasaki has this to say about the new design:
2010 Kawasaki Z1000 Photo Gallery
“A unique blend of Japanese art and technology, the 2010 Z1000’s styling takes a dramatic leap forward with the distinct look of an apex predator. Hunched-down and ready to pounce, its visual impact is much stronger than that of a naked sportbike, or a derivative copy of some Euro trend.”
But it’s more than the outside that’s been overhauled, the 2010 Z1000 bragging an all-new engine and frame as well. The previous incarnation of the Z1000 debuted in 2007 model year, still featuring a 953cc mill based off the ZX-9. The latest version sports an all-new 1043cc liquid-cooled Inline Four. Sporting a 77mm bore and 56mm stroke, the new Kwakker’s motor is fuel-injected and bolted to the frame as a stressed member.
Speaking of the frame, gone is the steel design of its predecessor, replaced by a “quick-steering” aluminum unit. Teamed with a three-piece aluminum subframe, the frame bolts to the new motor in four locations, three rigid and one of which is rubber mounted. Kawasaki fitted a secondary balance shaft to keep the Z1000’s mill from rattling too hard, though it promises “on this bike, a little bit of character is designed in.” Similar to the ZX-10R sportbike the frame beams “curve over the engine” for a narrow feel. Steering geometry, at 24.5 degree rake, 4.1 inch trail and 56.7 wheelbase appears virtually identical to the ’08 (wheelbase recorded at 56.9 inches). At 32.1 inch, the seat height is marginally lower (0.2 inch).
Suspension changes include the addition of compression damping to the 41mm inverted fork and its rebound and preload adjustability. The all-new monoshock rear features rebound and preload adjustment.
Nissin calipers up front are swapped out to radial-mount four-piston Tokico pinchers, which grab hold of Kawasaki’s dual 300mm wave rotors through input from the radial-pump master cylinder. A single piston-caliper bites down on a 250mm rotor out back.
Also new for 2010 are five-spoke cast wheels, which replace the 3-spoke units adorning the predecessor. As for the Z1000’s distinctive four-muffler exhaust system, it returns, with wide triangular cans on both sides. Like the previous model, however, each side canister is really a single muffler, with a faux dual-pipe cap retaining the four-can look found on the original Z.
2010 Kawasaki Versys First Look
The changes to the Versys are less dramatic, with Kawasaki opting to refine its popular mid-sized street bike with new styling lines and minor tweaks to improve rider and passenger comfort. Most noticeable is the new fairing, and its funkuliculous stacked headlight array. A new front fender, mirrors, muffler, clutch cover, radiator shrouds and a handful of other components complete the facelift redesign.
New rubber engine mounts look to decrease vibes from the 650 Parallel-Twin, along with revised hollow rubber-covered footpegs. The passenger accommodations are also spruced up, with the seat position fine-tuned, grab rails revised and a new seat cover material used . The three-position adjustable windscreen is larger too, for better wind protection and further improving the versatility for which the popular Kawi is named. .












No comments:
Post a Comment